Installing The Stabilizers; Lt1000 Mini - RIDGID SeeSnake LT1000 Manual

12. Adjust the platforms and side plates so the platforms
are aligned and level. Fully tighten down the screws
on the brackets and the mounting screws for the
laptop platforms.
13. Replace the right-hand cord-wrap and fasten it into
place with two screws. Note that the USB cable is
captured under the cord-wrap post as it exits the
LT1000.
Figure 16 – Mounting the Cord-Wrap (Note USB Cable cap-
tured under Cord-Wrap)
Figure 17 – Cord-wrap and USB Cable

Installing the Stabilizers

Stabilizers are supplied with the LT1000 which provide
greater reel stability when they are rotated out. Each sta-
bilizer has a spring-loaded plate inside it which holds the
stabilizer in place when installed.
Figure 18 – Stabilizers with Mini Reel
To install the stabilizers:
1. Remove the rubber foot from a leg of the frame.
2. Slide the stabilizer onto the leg of the frame, with
the solid face toward the top of the frame.
3. Replace the rubber foot and seat it firmly.
4. Repeat for all four legs. On the larger Standard unit,
install stabilizers only on the legs without wheels.
Figure 19 – Stabilizers installed

LT1000 Mini

Figure 20 – LT1000 Mini
Ridge Tool Company
®
SeeSnake LT1000
Rubber Foot
9