Saving Site Data - GE DigitalFlow GS868 Programming Manual

Panametrics steam ultrasonic mass flowmeter, 2-channel
Hide thumbs Also See for DigitalFlow GS868:
Table of Contents

Advertisement

Saving Site Data

Programming Site Data
The currently programmed site data may be stored in the Model
GS868's non-volatile memory by saving it as a site file. Up to ten site
file names, consisting of up to five characters each, may be stored at
any given time. To enter the
Program screen. Refer to Figure A-3 on page A-3.
1. Enter a new site file name and press
[F1]-[F4]
keys to select and overwrite an existing site file.
Note: The option bar will show only as many choices as there are
existing site files.
If ten site files are already stored in memory, an existing site file must
be deleted before a new site file name can be assigned. See Chapter 5,
Clearing Data, for details.
When a site file is stored in memory, it becomes the active site file
until another site file is created or retrieved. (See the next section for
instructions on retrieving a site file.) To verify that the site file has
been saved, use the [↑] key to scroll back to the
and see if the name appears on the option bar (use the [←] and [→]
keys to scroll through the list, if necessary). Whenever a new site file
name is saved, it is automatically assigned to the next available
function key.
IMPORTANT:
CLOCK
The
while the
file.
2. Use the [←] and [→] and
[EXIT]
press
to leave the User Program and return to measurement
mode.
SAVE
[F4]
menu, press
[ENT]
, or use the [←], [→] and
SITE NAME
I/O
and
data is not saved with the site file,
SYSTM
COMM
and
data is saved with the site
[F1]-[F4]
keys to select another menu, or
March 2008
at the initial User
prompt
1-49

Advertisement

Table of Contents
loading

Table of Contents