Using The Cli To View Stack Status - HP 3500 Series Advanced Traffic Management Manual

HP Switch(config)# show stack
Stacking - Stacking Status (This Switch)
Stack State
Transmission Interval : 60
Stack Name
Auto Grab
SN MAC Address
-- ------------- ------------- -------------------- -----------------
0 1cc1de-cfbc80 Big_Waters-0
1 000883-08f980 Big_Waters-1
Figure 6-22. Example of Using the Show Stack Command To List the Stacking Configuration for an
Individual Switch

Using the CLI To View Stack Status

You can list the stack status for an individual switch and for other switches
that have been discovered in the same subnet.
Syntax: show stack [candidates | view | all]
Viewing the Status of an Individual Switch. The following example
illustrates how to use the CLI to display the stack status for that switch. In this
case, the switch is in the default stacking configuration.
Syntax: show stack
: Commander
: Big_Waters
: Yes
System Name Device Type
HP Switch
HP Switch
Viewing the Status of Candidates the Commander Has Detected.
This example illustrates how to list stack candidates the Commander has
discovered in the ip subnet (broadcast domain).
Syntax: show stack candidates
HP Switch(config)# show stack candidates
Stack Candidates
Candidate MAC System Name
------------- ---------------------- ---------------------
0060b0-889e00 DEFAULT_CONFIG
Figure 6-23. Example of Using the Show Stack Candidates Command To List
Candidates
Stack Management for the 3500, 3500yl, 6200yl and 6600 Switches
Number of members
Members unreachable
Configuring Stack Management
: 14
: 0
Status
Commander Up
Member Up
Device Type
3500yl
6-29