Table of Contents
Advertisement
HP Switch(config)# mesh a1-a4, b3, c1, d1-d3
Command will take effect after saving configurationg and reboot.
HP Switch(config)# write memory
HP Switch(config)# boot
Device will be rebooted, do you want to continue [y/n]? y
Figure 4-9. Example of How To Configure Ports for Meshing
HP Switch# config
HP Switch(config)# no mesh c1
Command will take effect after saving configuration and reboot.
HP Switch(config)# write memory
HP Switch(config)# boot
Device will be rebooted, do you want to continue [y/n]? y
Figure 4-10. Example of Removing a Port from the Mesh
CLI: To Configure and View Switch Meshing
Configuration and Port Status Features
Feature
configuring switch meshing
viewing switch mesh status
CLI: Configuring Switch Meshing
Syntax: [no] mesh [e] < port-list >
Enables or disables meshing operation on the specified ports.
All meshed ports on a switch belong to the same mesh domain. Thus, to
configure multiple meshed ports on a switch, you need to:
1.
Specify the ports you want to operate in the mesh domain.
2.
Use write memory to save the configuration to the startup-config file.
3.
Reboot the switch. For switches with redundant management modules,
such as 8200zl switches, you must reboot both management modules. Use
the boot system ... command.
For example, to configure meshing on ports A1-A4, B3, C1, and D1-D3:
To remove a port from meshing, use the "no" version of mesh, followed by write
memory and rebooting the switch. For example, to remove port C1 from the
mesh:
Default
Menu
Disabled
n/a
n/a
n/a
Switch Meshing
Configuring Switch Meshing
CLI
Web
n/a
below
n/a
4-11
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
