Configuring The Security Appliance At The Local Site - Cisco ASA 5505 Getting Started Manual

Chapter 8 Scenario: Site-to-Site VPN Configuration
Configuring the Other Side of the VPN Connection
Note
What to Do Next
78-17612-01
You have just configured the local adaptive security appliance. Next, you need to
configure the adaptive security appliance at the remote site.
At the remote site, configure the second adaptive security appliance to serve as a
VPN peer. Use the procedure you used to configure the local adaptive security
appliance, starting with
section on page 8-4 and finishing with
the Wizard" section on page
When configuring Security Appliance 2, use same values for each of the options
that you selected for Security Appliance 1, with the exception of local hosts and
networks. Mismatches are a common cause of VPN configuration failures.
If you are deploying the adaptive security appliance only in a site-to-site VPN
environment, then you have completed the initial configuration. In addition, you
may want to consider performing some of the following steps:
To Do This ...
Refine configuration and configure
optional and advanced features
Learn about daily operations
Configuring the Other Side of the VPN Connection

"Configuring the Security Appliance at the Local Site"

"Viewing VPN Attributes and Completing
8-11.
See ...
Cisco Security Appliance Command
Line Configuration Guide
Cisco Security Appliance Command
Reference
Cisco Security Appliance Logging
Configuration and System Log
Messages
Cisco ASA 5505 Getting Started Guide
8-13