Built-in fryer with a cold zone with thermostatic control, switch, and safety thermostat (12 pages)
Summary of Contents for Smeg SFR30
Page 1
TIPO: FD30 MOD.: SFR30 The manufacturer cannot be held responsible for any inaccuracies due to printing or reproduction errors contained in the present booklet. The features of the picture diagrams included are purely indicative. We reserve the right to make any changes to our products that are deemed necessary or useful and in the interest of the user that are not detrimental to essential operating and safety features.
Page 2
DEEP FAT FRYER DESCRIPTION TYPE: FD30 1 Heating resistance 2300 W 2 Fryer kettle 3 Fryer control knob 4 Appliance on/off indicator lamp Caution: this appliance is designed for personal household use only.
Page 3
1) SWITCHING ON THE FRYER The fryer is controlled by a thermostat and it can be switched on by turning the knob clockwise to the position desired (see fig. 1). A red indicator lamp indicates it is switched on. Automatic cut-off switch...
Page 4
Hook the basket on the hanging device to drain the remaining oil. IMPORTANT ADVICE - Before frying for the first time, wash the fryer kettle and basket with a sponge and soap and water (or use a product available on the market).
2) CLEANING THE FRYER With the proper care the fryer will maintain its shine for a long time and will be easier to clean. Use a sponge, water and soap (or a product available on the market) to clean stainless steel parts, but only when the appliance is cool.
3) INSTALLING THE FRYER Remove outer packaging and inner packing of the various loose parts, then make sure the fryer is not damaged. In case of doubt do not use the appliance and contact a qualified technician.
4) SECURING THE FRYER To secure the fryer to the worktop the fastening clamps accompanying this booklet must be assembled. The following procedures must be carried out to do this: · remove all movable parts from the fryer; · turn the appliance over taking care to place it on a soft surface to avoid damaging the external surfaces;...
5) ELECTRICAL CONNECTIONS The electrical connection must be made in conformity with current regulations. Before making a connection, check that: - The capacity and outlets of the electrical installation are suitable for the maximum power output of the appliance (see the information label attached on the underside of the housing).
6) PART REPLACEMENT To replace components located inside the fryer the resistance should be lifted up and secured in the vertical position. Take out the oil kettle and loosen the four screws that are under it (see fig. 8). The work surface can now be detached from the worktop giving access to all internal components.
TECHNICAL ASSISTANCE AND SPARE PARTS Before leaving the factory, this equipment was tested and adjusted by skilled personnel so as to guarantee the best operating results. Original spare parts can only be found at our technical service centres and authorized stores. Every repair or adjustment necessary thereafter must be carried out with the greatest care by qualified personnel.