Advertisement
BATTERY INSTALLATION/REPLACEMENT
1. Remove the transmitter's end cap by inserting
the flat blade of a screwdriver in the cap's slot and
turning slightly counterclockwise.
2. Slide the transmitter PCB assembly out of its
case, taking care not to bend the antenna during
this step or later.
3. Remove the old battery, if replacing it.
SPECIFICATIONS
Dimensions:
.....................
3.0" H x 0.66" W x 0.8" D
(76.2mm) x (14.0mm) x (20.3mm)
Gap (xmtr to magnet): ................
Operating temperature:
0 - 50º C, non-condensing
This device complies with Part 15 of the FCC Rules and RSS 210 of Industry Canada. Operation is subject
to the following two conditions: (1) This device may not cause harmful interference. (2) This device must
accept any interference received, including interference that may cause undesired operation.
Cet appareil est conforme à la partie 15 des règles de la FCC & de RSS 210 des Industries Canada. Son
fonctionnement est soumis aux conditions suivantes : (1) Cet appareil ne doit pas causer d'interférences
nuisibles. (2) Cet appareil doit accepter toute interférence reçues, y compris les interférences causant un
reception indésirable.
The user shall not make any changes or modifications to the equipment unless authorized by the Installation
Instructions or User's Manual.
Unauthorized changes or modifications could void the user's authority to operate the equipment.
Note: For UL certified installations, this product is Listed for Residential use only.
For the latest warranty information, please go to:
www.honeywell.com/security/hsc/resources/wa
ÊK9485V1mŠ
K9485V1 10/05 Rev. E
4. Observe correct polarity and insert the fresh
5. Slide the PCB assembly back into its case,
6. Replace the end cap. Line up the projections on
Battery:
0.5" (12.7mm) max
BATTERY CAUTION: Risk of fire, explosion
and burns. Do not recharge, disassemble, heat
above 212° F (100° C) or incinerate. Dispose of
used batteries properly. Keep away from
children.
FCC IC STATEMENT
FCC STATEMENT
2 Corporate Center Drive, Suite 100
P.O. Box 9040, Melville, NY 11747
Copyright© 2008 Honeywell International Inc.
www.honeywell.com/security
battery into the battery holder (position the battery
as shown in Figure 2).
battery end first (the reed switch end must be close
to the end cap).
the cap with the openings at the edge of the case.
Press the cap gently against the PCB and turn the
cap (via its slot) slightly clockwise, thereby locking
it in place.
.........................
1.5VDC, AAA Lithium
(Energizer L92) or AAA
Alkaline (Duracell MX2400,
Panasonic AM-4PI, Eveready
Energizer EN92)
Advertisement
