Ignition And Starter Switch; Main Fuse - Husqvarna Rider 100 series Workshop Manual

Ignition and starter switch

1 Unplug the connector from the ignition switch by
pulling straight down.
2 Remove the ignition key and the rubber seal.
3 Remove the nut and the ignition switch.
4 Assemble in reverse order. Make sure the
connector goes into the right position (click lock).
52 – English

Main fuse

The main fuse is placed in a detachable holder
behind the battery under the protective cover.
Type: Flat pin, 15 A.
Do not use any other fuse when changing.
A blown fuse is indicated by a burnt link. Pull the
fuse from the holder when replacing it.
The fuse is intended to protect the electrical
system. If it blows again shortly after replacement, it
is due to a short circuit, which must be fixed before
the machine can be put into operation again.
Electrical System