Removing/Fitting Steering Shaft - Husqvarna Rider 100 series Workshop Manual

1
Removing/Fitting the Steering Shaft
1 Loosen the rear fastening of the steering
cables (1).
2 Remove the frame cover by loosening the
screws. 3 pcs screws:
3 Remove the steering wheel and steering wheel
rod by punching the pin out with a mandrel,
lift the steering wheel and steering wheel rod
upwards.
28 – English
6
5
3
4 Unscrew the screw (2) in the lower edge of the
steering wheel rod.
5 Pull the steering wheel shaft (3) upwards and
move the lower part of the shaft backwards to
pull off the steering chain (4).
6 Move the upper bearing (5) upwards until it
moves freely from the steering wheel shaft (3). If
the bearing needs replacement, the bushing (6)
must be tapped out of the bearing.
7 Remove the steering wheel shaft (3) in a
downwards movement.
8 To assemble the steering shaft, follow the
instructions in the reverse order.
4
2