Table of Contents
Advertisement
Function Settings > Receive/Forward
• Fax Settings >Select RX Mode > Fax/Tel (Auto Switch) (*1)
• Fax Settings > Remote RX > ON (*1)
• Fax Settings > Set Number Display > ON (*1)
Function Settings > Send
• Fax Settings > Modem Dial-in Settings > ON (*1)
Other Settings
• Volume Settings key > Fax Volume Settings > Incoming Fax Ring > ON (*1)
*1: This may not be displayed depending on the country, model, and configuration of the options.
*2: This must be already registered on Google Cloud Print in advance.
Hardware status
• It is connected to the coin vendor.
System Performance Status
• The system is running/communicating.
CAUTION:
The system is in a running/communicating state for approx. 10 minutes after startup in many cases.
Quick Startup
To realize faster startup, power configuration has been changed to always supply power to the Low Voltage Power Supply PCB
and Main Controller PCB. Consequently, the Touch Panel can be operated 4 seconds after turning ON the Main Power Switch.
Even when the Main Power Supply Switch is OFF, power is supplied to the following PCBs:
Low-Voltage Power Supply PCB
Main Controller PCB
NOTE:
The quick startup function can be set from "Settings/Registration".
• Settings/Registration > Preferences > Timer/Energy Settings > Quick Startup Settings for Main Power
[On]: Quick startup is executed (default)
[Off]: Quick startup is not executed
Disconnect the power plug when performing work with the possibility to come in contact with the PCBs above. If a conductive
material comes in contact with the PCB, short circuit may occur in the PCB, and may cause damage on it.
The following label is used at the place where attention is required.
Conditions for not executing quick startup
This machine does not execute quick startup if the following conditions are met at first startup after the power plug is connected
to the outlet.
Connection status of the hardware
• The coin vendor is connected.
Either of the following network settings is set to "ON":
Settings/Registration > Preferences > Network
• AppleTalk Settings > Use AppleTalk > ON
Quick startup setting ON
Power is supplied
Power is supplied
Quick Start
Plug Off
83
2. Technology
Quick startup setting OFF
Power is supplied
OFF
Advertisement
Table of Contents
