Table of Contents
Advertisement
Available languages
Available languages
007015
With tool disconnected, make daily inspection to assure
free movement of the contact element and trigger. Do not
use tool if the contact element or trigger sticks or binds.
007016
Make sure that the trigger is locked when the change
lever is set to the
position.
1
2
007017
When the tool is not to be used for an extended period of
time, lubricate the tool using pneumatic tool oil and store
the tool in a safe place. Avoid exposure to a direct
sunlight and/or humid or hot environment.
007018
1. Trigger lock
2. Change lever
8
000219
Maintenance of the compressor, air set and air
hose
1
004317
1
004318
After operation, always drain the compressor tank and
the air filter. If moisture is allowed to enter the tool, It may
result in poor performance and possible tool failure.
Check regularly to see if there is sufficient pneumatic oil
in the oiler of the air set. Failure to maintain sufficient
lubrication will cause O-rings to wear quickly.
004319
Keep the air hose away from heat (over 60°C, over
140°F), away from chemicals (thinner, strong acids or
alkalis). Also, route the hose away from obstacles which
it may become dangerously caught on during operation.
Hoses must also be directed away from sharp edges and
areas which may lead to damage or abrasion to the hose.
1. Drain cock
1. Air filter
1. Oiler
2. Pneumatic oil
1
2
Advertisement
Table of Contents
