Specifications - Makita GS5000 Instruction Manual

ENGLISH (Original instructions)
1-1. Switch trigger
1-2. Lock lever
2-1. Hex wrench
2-2. Hex bolt
2-3. Hex lock nut
2-4. Tighten
2-5. Loosen
3-1. Wing bolt
3-2. Support cover
4-1. Lock nut
4-2. Grinding wheel
4-3. Spindle
5-1. Screwdriver

SPECIFICATIONS

Maximum wheel capacity (diameter X thickness)
No load speed (min
Overall length
Net weight
• Due to our continuing program of research and development, the specifications herein are subject to change without notice.
• Specifications may differ from country to country.
• Weight according to EPTA-Procedure 01/2003
Intended use
The tool is intended for grinding ferrous materials or
deburring castings.
Power supply
The tool should be connected only to a power supply of
the same voltage as indicated on the nameplate, and
can only be operated on single-phase AC supply. They
are double-insulated and can, therefore, also be used
from sockets without earth wire.
Model GS5000, GS6000
Noise
The typical A-weighted
according to EN60745:
Sound pressure level (L
Sound power level (L
Uncertainty (K) : 3 dB(A)
Wear ear protection
Explanation of general view
5-2. Inner flange
5-3. Lock nut wrench
5-4. Lock nut
6-1. Hex nut
6-2. Outer flange (convex type)
6-3. Grinding wheel
6-4. Spindle
7-1. Hex nut
7-2. Outer flange (flat type)
7-3. Grinding wheel
7-4. Spindle
8-1. Screwdriver
8-2. Hex wrench
Model
Spindle thread
-1
)
With support cover
Without support cover
With support cover
Without support cover
Safety class
noise level determined
) : 83 dB(A)
pA
) : 94 dB(A)
WA
GS5000
125 mm × 20 mm
590 mm
588 mm
5.0 kg
4.9 kg
ENE050-1
Vibration
The vibration
determined according to EN60745:
ENF002-2
Work mode : surface grinding
Vibration emission (a
Uncertainty (K) : 1.5 m/s
The declared vibration emission value has been
•
measured in accordance with the standard test
method and may be used for comparing one tool
with another.
ENG905-1
The declared vibration emission value may also be
•
used in a preliminary assessment of exposure.
The declared vibration emission value is used for
•
main applications of the power tool. However if the
power tool is used for other applications, the
vibration emission value may be different.
WARNING:
The vibration emission during actual use of the
•
power tool can differ from the declared emission
value depending on the ways in which the tool is
used.
3
8-3. Inner flange
8-4. Hex nut
11-1. Exhaust vent
11-2. Inhalation vent
12-1. Handle R
12-2. Dust cover attachment R
12-3. Handle L
12-4. Dust cover attachment L
13-1. Commutator
13-2. Insulating tip
13-3. Carbon brush
14-1. Brush holder cap
14-2. Screwdriver
150 mm × 20 mm
M14 or 1/2" (country specific)
5,600
/II
total value (tri-axial
) : 2.5 m/s
h,SG
2
GS6000
590 mm
588 mm
5.2 kg
5.0 kg
ENG900-1
vector sum)
2
or less
ENG902-1