Advertisement
Limitless™ WGLA Series
The battery will need to be activated in the WGLA and proper power applied to the WPMM (green
illuminated) before proceeding with this pairing procedure. Once the pairing is completed, the WGLA selected will
only communicate with the WPMM it was paired to and no other device.
Step
Action
1
Completely read this procedure before starting in order to understand the timing of events that need to be
performed.
2
WGLA: Remove (if required) the two screws
locate the function button
3
WPMM: Press the Function button
eight seconds at which time the green
function button immediately as it has entered the pairing mode.
4
WGLA: Within a 30 second interval of Step 3, depress the WGLA switch function button
and hold depressed for more than one second and less than 12 seconds at which time the orange
turns on. While in pairing mode, the orange led will flash on for 100 ms every second. The orange
flashes three times 100 ms on, 100 ms off when pairing succeeds. If pairing does not succeed, the orange
LED will turn off and user will need to repeat steps starting with Step 3.
5
WPMM: Successful pairing will be indicated by the green
flash and remaining on for a few seconds before turning off. A short buzzer beep will also occur.
6
To confirm proper pairing between the WGLA and WPMM, actuate the WGLA, and the red LED
illuminate along with a buzzer sound.
7
Record the WGLA Sequence # on identification labels
locations (See Figure 6).
8
Repeat Steps 2-7 to add additional WGLA switches. Up to 16 WGLAs can be paired to a single WPMM.
4
Honeywell Sensing and Control
on the housing cover (See Figure 3) of the WGLA and
to be used in Step 4.
on WPMM (See Figure 4) for more than four seconds and less than
and amber
Issue 1
LEDs will be flashing which indicates to release the
and amber
LEDs (See Figure 4) ceasing to
and apply to the WGLA housing in desired
50053338
LED
(See Figure 5)
LED
LED
should
Advertisement
