Advertisement
UV100E ULTRAVIOLET SYSTEMS
SPECIFICATIONS
IMPORTANT
This product is tested and calibrated under closely
controlled conditions and some minor differences in
performance can be expected if those conditions are
changed. The specifications in this publication do not
include normal manufacturing tolerances; therefore,
an individual unit may not exactly match the listed
specifications.
TRADELINE® Models available:
The UV100E Ultraviolet System is available in three models: a
single-lamp air treatment system, a dual-lamp air treatment
system, and a surface treatment system.
• UV100E Air Treatment Systems (single-lamp and dual-
lamp) are mounted in the return air duct of an HVAC
system. The single-lamp unit has moderate efficiency and
the dual-lamp unit has high-efficiency performance against
airborne bacteria in return air applications.
— Without Enviracom hooked up: monitors air flowing
through ductwork using supplied airflow sensor
mounted to backside of unit. Operates lamp when air
is flowing (120 fpm minimum), leaving lamp on for 40
minutes after airflow stops. If airflow resumes during
the 40 minutes, the timer resets to 40 minutes. When
no airflow is detected for 40 minutes, the lamp turns off
until the next occurrence of airflow.
— With Enviracom hooked up: monitors thermostat load
information instead of using airflow sensor to operate
on and off.
• UV100E Surface Treatment System is mounted in the
supply-side air duct or downstream or upstream from air
conditioner evaporator coils in HVAC system. It reduces
mold growth and spores on duct surfaces, coils and drip
pans.
— Does not use an airflow sensor.
— Without Enviracom hooked up: operates steady on/off
cycle: lamp operates three hours on, three hours off
for a total two-year life cycle.
— With Enviracom hooked up: after initial three hours run
time, operates three hours on and three hours off dur-
ing times when the evaporator A-coil may be exposed
to moisture, including when the control sees a cooling
call and for 30 days after the last cooling occurred.
This operation extends the bulb life beyond two years.
ORDERING INFORMATION
When purchasing replacement and modernization products from your TRADELINE® wholesaler or distributor, refer to the
TRADELINE® Catalog or price sheets for complete ordering number.
If you have additional questions, need further information, or would like to comment on our products or services, please write or
phone:
1. Your local Honeywell Automation and Control Products Sales Office (check white pages of your phone directory).
2. Honeywell Customer Care
1885 Douglas Drive North
Minneapolis, Minnesota 55422-4386
In Canada—Honeywell Limited/Honeywell Limitée, 35 Dynamic Drive, Toronto, Ontario M1V 4Z9.
International Sales and Service Offices in all principal cities of the world. Manufacturing in Australia, Canada, Finland, France,
Germany, Japan, Mexico, Netherlands, Spain, Taiwan, United Kingdom, U.S.A.
68-0262—5
Efficiencies:
• UV100E Surface Treatment System: Kills up to 99.9% of
mold on system cooling coils.
— Test performed in a test duct showed reduction in col-
ony-forming aspergillus niger mold spores when sur-
face was irradiated at a distance of 18 in. for three
hours in still air, using new lamps.
• UV100E Air Treatment System (dual-lamp): Kills up to 87%
of airborne bacteria passing by the system.
— Test showed single-pass kill-rate of serratia marce-
scens bacteria in a clean metal 12 in. x 25 in. duct at
an airflow rate of 2000 cfm using new lamps.
• UV100A Air Treatment System (single-lamp): Kills up to
70% of airborne bacteria passing by the system.
— Test showed single-pass kill-rate of serratia marce-
scens bacteria in a clean metal 12 in. x 25 in. duct at
an airflow rate of 2000 cfm using new lamps.
Enviracom™ Communications Capabilities:
• Communicates with homeowner through three-wire
communication bus using 24 Vac thermostat connections.
— Hooked up to single-lamp and dual-lamp Air Treat-
ment System: uses thermostat load information
instead of airflow sensor.
— Hooked up to Surface Treatment System: uses
thermostat load information to operate during times
evaporator A-coil may be exposed to moisture to
extend bulb life beyond two years.
• Sends messages to communicate reset and receives
remote reset, when available.
— Lamp change indication cannot be reset by cycling
power.
— When Enviracom is transmitting messages, shows
flashing green Enviracom LED on bottom of unit.
Electrical Ratings:
Voltage Rating: 120 Vac, 60 Hz.
Current and Power Ratings:
Model
UV100E1043 Air Treatment
System (single lamp)
UV100E2009 Air Treatment
System (dual lamp)
UV100E3007 Surface
Treatment System
2
Input Power
Bulb Wattage
(A)
(W)
0.46
18
0.62
36
(each bulb)
0.74
36
Hide quick links:
Advertisement
