Preparing Connection - RIDGID PEX-One Operator's Manual

PEX-One Crimp Tool
Figure 7 – Removing and Installing Dies
Dies should fit snugly and securely. With jaws
closed, dies should align. Always use a matched
set of RIDGID dies. If there are any issues re-
garding proper die fit, do not use tool. Do not
operate tool without dies installed.
Size
(Marked "ASTM")
½"
¾"
1"
Figure 8 – Die Identification Chart
Die Caddy
Die caddy is available to hold dies when not in
use. For convenience, it can be clipped to the
crimp tool (Figure 9) or belt. Dies push in/pull
out and are held in place by a spring.
Figure 9 – Die Caddy Use

Preparing Connection

Prepare connection per fitting manufacturer's
instructions. Confirm that fitting is fully inserted
into tube and any ring/sleeve is properly placed.
These instructions are generalized
NOTI E
practices for multiple fitting systems. Always
follow fitting manufacturers specific installa-
tion instructions to reduce risk of improper
connections and extensive property damage.
8
Die Detent
Crimp
Profile
ASTM F1807
Bronze
Silver
Gold
Clip
Crimping Fitting
1. Make sure that proper dies for application
have been installed.
2. With dry hands, install a fully charged
bat tery into crimp tool. Move ON/OFF
(I/O) switch to ON (I) position. The work
lights should come on. See Work light/sta-
tus chart for other tool conditions.
3. Depress jaw lever to fully open jaws.
4. Place dies squarely over fitting, aligning the
contour of die to fitting. Release jaw lever
so dies sit on fitting. (Figure 10). Improper
tool alignment can result in an improper
crimp, cause leaks or damage tool. Do
not hang tool from fitting.
Figure 10 – Tool Square to Fitting
Dies
5. Reconfirm that the fitting is appropriately
positioned. Remove your thumb from jaw
lever. Keep fingers and hands away from
jaws to reduce risk of crushing injuries be-
tween dies and between jaws and sur-
roundings.
Depress and hold run switch to operate
tool. When the crimp is complete, the
tool will automatically reverse to start po-
sition. Release run switch.
If run switch is released prior to crimp
completion, tool will stop and crimp can-
not be completed. Depress reverse button
(Figure 1) and crimp connection again.
Use this procedure in case of emergency,
if tool must be removed before a crimp is
completed or if tool malfunctions during a
crimp.
Any time reverse button is de-
NOTI E
pressed, crimp is NOT complete and the con-
nection must be crimped again to ensure
completion.
6. With crimp complete, depress jaw lever to
open jaws and remove from fitting. Avoid
085-003-980.10_REV. A