Timer Transmission - Sharp FO-IS115N Operation Manual

Timer Transmission

Timer Transmission
The Timer function allows you to store a fax transmission job to be performed
automatically at a time you specify. The time can be specified up to 24 hours
in advance.
♦
You can use this function to take advantage of lower off-peak rates without
having to be there when the transmission is performed.
♦
Up to 15 timer jobs can be stored at once.
♦
Multiple destinations can be entered if all are stored in Rapid Keys or
Speed Dial numbers. A Group Key can also be used (once a Group Key is
used, no further destinations can be entered).
♦
A destination can be specified by entering a full fax number with the
number keys, however, in this case only one destination can be entered.
1
Load the document(s).
•
If desired, press
2
Press
3
Press
4
Enter the time at which the fax is to be transmitted.
•
Enter a two-digit number for the hour ("00" to "23") and a two-digit number
for the minute ("00" to "59").
Example: 9:25
5
START
Press
6
Enter the fax number using one of the methods below:
100
RESOLUTION
to set the resolution and/or contrast.
.
TIMER
to select "SET".
.