Table of Contents
Advertisement
JOB MEMORY
Frequently used job programs can be stored in one of nine storage
registers. This is convenient for quick job recall without losing time
manually reprogramming each aspect of the job.
All functions that can be set in the copy mode except the copy
quantity setting can be stored in the job memory.
If any function which has been stored in a job program is modified
by a key operator program, the key operator settings will supercede
the previous setting.
KEY OPERATOR
Job memory replacement/deletion can be
prohibited. See page 28 of the KEY OPERATOR'S GUIDE.
8
9
PROGRAM
IT
0
P
RECALL
STORE/DELETE
JOB PROGRAMS
PRESS PROGRAM NUMBER.
RECALL
STORE/DELETE
MAKE COPIER SELECTIONS AND PRESS
[OK].
8 11
1.
1
2
2.
11
17
3.
8 14
1
2
AUTO
AUTO
8/ 11
1
2
EXPOSURE
PAPER SELECT
2-18
Storing a job program
Press the PROGRAM key.
1
The JOB PROGRAMS screen will appear on the touch panel.
C
CLEAR
Press the "STORE/DELETE" key on the touch panel.
2
To cancel the job memory mode, press the "EXIT" key or the
CLEAR ALL (
Select a program number from 1 to 9 on the touch panel.
3
EXIT
The numbers which are highlighted are job registers which
already contain job programs.
If a program number containing a registered job program is
selected, a message will appear to confirm the selection. To
replace a stored job program with a new program, press the
"STORE" key and proceed to the next step.
To cancel replacement, press the "CANCEL" key.
Make all copier selections to be stored.
4
OK
NOTE:
CANCEL
When you store color balance settings, make settings before
pressing the PROGRAM key in step 1 because sample copies
cannot be made after pressing the PROGRAM key.
100%
Press the "OK" key to complete the storage.
5
COPY RATIO
) key.
CA
Advertisement
Table of Contents
