NETGEAR Arlo Quick Start Manual page 6

b. Press the Sync button on the back of
the base station for about two seconds.
Release the button.
c. Wait for the Sync Status LED to blink
green.
Res et
DC
SYN C et
ern
Eth
e t
R e s
C
S Y N e t
e r n
E t h
10
d. Press the Sync button on top of the
camera for about two seconds. Release
the button.
A blue LED on the camera blinks slowly
when the sync process starts. The blue
LED blinks rapidly to confirm sync.
The camera is ready for viewing.
Note: If the LED blinks amber quickly, the sync is not
successful. You must repeat the sync process.
Syncing more than one camera?
Go to page 9 and repeat steps 5a
through 5d for each camera.
11