Cisco NCS 1001 Configuration Manual page 25

Configuring NCS 1001 Using Data Models
Parameter
safety-control-mode
rx-low-threshold
Description
<?xml version="1.0"?>
<rpc message-id="102" xmlns="urn:ietf:params:xml:ns:netconf:base:1.0">
<edit-config>
<target>
<candidate/>
</target>
<config xmlns:xc="urn:ietf:params:xml:ns:netconf:base:1.0">
<interface-configurations
xmlns="http://cisco.com/ns/yang/Cisco-IOS-XR-ifmgr-cfg">
<interface-configuration>
<active>act</active>
<interface-name>Ots0/2/0/0</interface-name>
<optics
xmlns="http://cisco.com/ns/yang/Cisco-IOS-XR-controller-optics-cfg">
<optics-ots-osri>true</optics-ots-osri>
</optics>
</interface-configuration>
</interface-configurations>
</config>
</edit-config>
</rpc>
<?xml version="1.0"?>
<rpc message-id="102" xmlns="urn:ietf:params:xml:ns:netconf:base:1.0">
<edit-config>
<target>
<candidate/>
</target>
<config xmlns:xc="urn:ietf:params:xml:ns:netconf:base:1.0">
<interface-configurations
xmlns="http://cisco.com/ns/yang/Cisco-IOS-XR-ifmgr-cfg">
<interface-configuration>
<active>act</active>
<interface-name>Ots0/2/0/0</interface-name>
<optics
xmlns="http://cisco.com/ns/yang/Cisco-IOS-XR-controller-optics-cfg">
<optics-ots-safety-control-mode>auto</optics-ots-safety-control-mode>
</optics>
</interface-configuration>
</interface-configurations>
</config>
</edit-config>
</rpc>
Data Models Configuration Guide for Cisco NCS 1001
Configure OTS Controller
21