Display Modes - Honeywell WPS Series Quick Start Manual

User Manual for the
WPS Series Wireless Pressure Sensor
5 OPERATION
5.1 Overview

5.1.1 Display Modes

The sensor has the following display modes.
• PV display: Displays the Process Value and units
• Connection (Link) status: Displays a label calculated from the link signal amplitude
5.2 Sensor PV Display
On the LCD display, the following information is displayed in sequence. First, the PV will be displayed for 3 seconds, then the Link Sta-
tus will be displayed for 2 seconds. This sequence will repeat at a rate determined by the Publication Rate and the LCD Display Rate.
Table 2. PV Display
Item Displayed
PV value
PV engineering units
Link Status
Table 3. PV Engineering Units
Item Displayed
Pa
kPa
Bar
Psia
Psig
Table 4. Sensor Link Status Display
Display Meaning
BEST Best strength – approx.-75 to -25 dBm
GOOD Good strength – approx. -75 to -85 dBm
BAD Very weak signal – approx. -100 to -85 dBm
NoRF Unuseable signal level - no link possible
DWLD Not a failure, indicates that a software download
is in progress.
12 Honeywell Sensing and Control
Example Details
50.0 Latest PV value.
psig See Error! Reference source not found.
GOOD Received Signal strength - See Table 5 3 Sensor Link Status Display
Details
Pascals
KiloPascals
Bar
Pounds per square inch absolute
Pounds per square inch gauge
Suggested Action
No action required
No action required
Troubleshoot antenna, antenna cables
Evaluate signal path and distance to nearest FDAP
Substitute other provisioned sensor into same location
Troubleshoot antenna, antenna cables
Evaluate signal path and distance to nearest FDAP
Verify sensor is properly provisioned w/ WDM UI
Substitute other provisioned sensor into same location
No action required, normal indications will resume after down-
load is complete
50095584
ISSUE 1