Advertisement
9. Insert a 6.5 mm (17/64 in) drill bit through the
mounting hole in the sub-frame as shown. Make a
mark on the inside of the rear fender by twisting the
drill bit with your fingers.
<View from the underside of the rear fender.>
6.5 mm (17/64 in)
DRILL BIT
MOUNTING HOLES
10. Repeat the above procedure on the remaining right
and left side mounting holes.
11. Remove the rear fender as shown.
CLIP
4 of 8
SUB-FRAME
REAR FENDER
HARNESS
Pull out from
the rear fender.
12. Drill the rear fender at the marked points as shown.
•
Remove any burrs from the edge of the hole.
<Right side>
REAR FENDER
<Left side>
ELECTRIC DRILL
(30 mm HOLE SAW)
08L56-MFY-1002-91
MARKED POINT
WOOD BLOCK
ELECTRIC DRILL
(30 mm HOLE SAW)
MARKED POINT
REAR FENDER
WOOD BLOCK
© 2010 American Honda Motor Co., Inc - All Rights Reserved.
Advertisement
