Advertisement
R
epair
[3] DISASSEMBLY/ASSEMBLY
[3]-3. Terminal Cover
ASSEMBLING
Assemble Terminal cover to Charger case as described in Fig. 5.
Fig. 5
1. Set Compression spring 4 (231474-6/ 2 pcs) in place
on the back of Terminal cover as illustrated below.
2. Compressing each Compression spring 4 (231474-6),
insert the boss on the back of Terminal cover into
the oval hole of Charger case, then fit the end of
each Compression spring 4 in the recessed portion
of Charger case as illustrated below.
boss on the back of
Terminal cover
Charger case
Terminal cover
Compression spring 4
(231474-6/ 2 pcs)
Compression spring 4
(231474-6/ 2 pcs)
recessed portion
oval hole
3. Assemble Terminal cover to Charger case
by tightening PT3x10 Tapping screw.
Note:
0.5 N.m is the recommended tightening
torque for smooth sliding of Terminal cover.
Terminal cover
PT3x10
Tapping screw
P 4/ 5
Advertisement
