Assembling - Makita DTR180 Original Instructions Manual

Assembling

When cleaning is finished, assemble the parts accord-
ing to the following procedure.
1. Install cutter A and link arm A to fit the shape of
arm plate A.
1
► 1 . Cutter A 2. Link arm A 3. Arm plate A
2. Install cutter B and the top plate onto arm plate A.
(Install cutter B on cutter A and link arm A.)
1
2
3
► 1 . Cutter B 2. Top plate 3. Arm plate A 4. Cutter A
5. Link arm A
NOTICE:
Face the projection of cutter B down-
ward, and install the cutter as shown in the figure.
3. Align the pipe of the tool with the groove inside the
wire guide B, and assemble them.
► 1 . Pipe 2. Groove 3. Wire guide B
2
3
4 5
1
2
3
4. Fix wire guide B by temporarily tightening bolt A.
1
► 1 . Bolt A 2. Wire guide B
5. Install the contact plate cover in the direction of
the arrow.
1
► 1 . Contact plate cover
6. Fix wire guide B and contact plate cover securely
by tightening bolt A and bolt B.
3
► 1 . Wire guide B 2. Contact plate cover 3. Bolt A
4. Bolt B
17 ENGLISH
2
4
2
1