Makita DTR180 Original Instructions Manual page 10

2. Peel off the tape that holds the wire, and pull the
tip of the wire out.
2
1
► 1 . Tape 2. Tip of wire
3. Open the reel cover.
► 1 . Reel cover
4. Mount the wire reel on the tool in the orientation
shown in the figure.
► 1 . Wire reel
NOTICE:
Be sure to mount the wire reel in the
orientation shown in the figure. If it is mounted the
other way around, the wire will be released and may
be twisted.
1
1
10 ENGLISH
5. Make the tip of the wire straight, and pass the wire
through the guide.
► 1 . Guide
NOTE: If the tip of the wire is bent when it is passed
through the guide, the wire may become jammed in
the tool.
NOTE: If you force the wire when trying to pass it
through the guide, the wire may become jammed.
6. Pull the wire out approximately 10 mm from the tip
of the arm.
► 1 . Arm 2. Approximately 10 mm
NOTICE:
If the length of the pulled-out wire is
insufficient, the wire may be broken off when tied,
or tying strength may be compromised due to
insufficient wraps.
1
2
1