S/W Versions; Documents; Applications; Pc S/W - Panasonic EBL512 Operating Instructions Manual

Panasonic Eco Solutions Nordic AB
MEW01457 Rev: -
3.2
3.3
3.4
3.5
3.5.1
Operating Instructions Fire alarm system EBL512, V2.7.x
The batteries and the rectifier are connected to the Charger board
7
(1657) , which handles the charging of the batteries, etc. Low or High
current charging mode is selected depending on the wanted backup
battery capacity (backup time) and/or the EBL512 current
consumption. See the EBL512 Planning Instructions, chapter "Power
supply" for more information.

S/W versions

Due to continual development and improvement, different S/W
versions can be found. When installing a new control unit in a system
with "older" control units, you might have to update the S/W in the
old control units. It is highly recommended to have the same S/W
version in all control units but as from S/W version 2.X.x the same
S/W version is required in all control units.
In a mixed system (see chapter "Mixed system", page 11) the
EBL512 control units have to have the S/W EBL512 version 2.7.x
and the EBL512 G3 control units have to have the S/W EBL512 G3
United version 2.7.x

Documents

The following documents are available:
 Operating instructions (this document)
 Planning instructions
 Drawings (e.g. connection diagrams)
Normally information that is found in one document is not to be found
in another document, i.e. the documents complement each other.

Applications

The EBL512 system is intended for small, medium and large
installations. The intelligent control units offer the system designer
and end user a technically sophisticated range of facilities and
functions. Programming (PC S/W Win512) and commissioning of the
control unit / system is very easy. Start with one control unit and then,
when required, add more units. The TLON network makes it possible
to install the control units in one building or in many buildings.

PC S/W

A number of PC S/Ws are used together with the EBL512 system.

Win512

Win512 version 2.7.x is used for programming and commissioning of
one or more EBL512 control units (version 2.7.x) but in a mixed
system (see chapter "Mixed system", page 11) it is also used for the
EBL512 G3 control units (United version 2.7.x), i.e. to:

create / download / backup (upload) the site specific data (SSD)
7
The former Charger board for EBL512 had the type no. 1557.
13