Power Cabinet Alarm Cable Pin/Signal Information; Dc Power Interconnect To Rf Cabinet - Motorola SC 4812ET RF Hardware Installation Manual

Cabinet Cabling
– continued
Power Cabinet Alarm Cable
Pin/signal Information
RF Cabinet Punch Block
Pin Location
1T
1R
2T
3T
3R
4T
4R
5T
5R
5
6T
6R
7T
DC Power Interconnect to RF
Cabinet
Tools and equipment required
110
See Table 5-27 for complete pin/signal information.
Table 5-27: Pin–Out for Power Cabinet Punch Block
Signal
Control (NO)
Control (NC)
Control (Com)
Rectifier Fail
AC Fail
Exchanger Fail
Door Alarm
Major Alarm
Battery Overtemp
Minor Alarm
Rectifier Overtemp
Alarm Return
The objective of this procedure is to connect the DC power cabling to
the RF Cabinet from the Power Cabinet.
The following tools are required to install the power cables:
– Thomas & Betts TBM14 Hydraulic crimping tool with color keyed
crimp die set (or equivalent). Contact Thomas & Betts for
information concerning equivalent tools.
– 17 mm socket
– Torque wrench capable of 110 in–lbs
SC 4812ET RF and Power Cabinet Hardware Installation Manual
TM
Wire Color
Blue
Blk/Blue
Yellow
Blk/Yellow
Green
Blk/Green
White
Blk/White
Red
Blk/Red
Brown
Blk/Brown
WARNING
ALL power must be removed from the system until all
connections are made to both the RF and Power Cabinet.
Ensure that all breakers in both the RF and Power Cabinet
are turned in the "OFF" (opened) position.
DRAFT
Power Cabinet Punch
Block Pin Location
1T
1R
2T
3T
4T
5T
6T
7T
8T
9T
10T
11R
Apr 2001
V04.03