Makita 3706 Instruction Manual page 7

2
3
1
1. Shoe
2. Loosen
3. Tighten
4. Thumb screw
2
3
1
1. Shoe
2. Circular guide
3. Projections
2
1
1. Shoe
2. Circular guide
3. Thumb screw
NOTE:
1. When using this tool, the rotating action causes the tool to pull. The less
pressure applied to the tool causes less pull and provides a more accu-
rate cut. Excessive pressure or fast cutting can cause the bit to dull or
break premature.
2. When cutting drywall around outlet boxes, cut in a counterclockwise
direction for ease of cut.
3. The standard bit included with this tool is for cutting drywall only. When
cutting materials other than drywall, do not use the standard drywall
guide bit.
Circular guide
Circular cutting diameters: 10 cm - 34 cm
Installing circular guide
001631
Release the thumb screw which serves to secure the shoe.
4
Align the projections in the circular guide with the grooves in the shoe, and
001632
secure the shoe and circular guide using the thumb screw.
To adjust the cutting depth, proceed first by loosening the thumb screw and
001633
then by sliding the shoe and circular guide together. After completion of the
adjustment, tighten the thumb screw securely.
3
7