Operation - Makita 3706 Instruction Manual

1 2
3
1. Adapter
2. Collet nut
3. Collet cone

OPERATION

6
Changing the collet cone
004554
CAUTION:
• Use the correct size collet cone and adapter for the bit which you
intended to use.
• Do not tighten the collet nut without inserting a bit, or the collet cone will
break.
To change the collet cone, loosen the collet nut and remove. Remove installed
collet cone and adapter and replace with desired collet cone and adapter.
Reinstall collet nut.
001627
CAUTION:
• Avoid forcing the bit to bend or twist. It may snap.
• Before turning the tool on, make sure the bit and collet nut are securely
tightened.
Hold the tool secure with the bit pointing in a safe direction not contacting any
surface and slide the switch to the "ON'' position. Wait until the tool attains full
speed.
When starting the multipurpose bit into the material, hold the tool at approxi-
mately a 45 degree angle with the edge of the shoe base contacting the mate-
rial.
Carefully bring the tool to a straight position so the shoe base is in full contact
001628
with the material.
When inserting the drywall guide bit into the drywall, carefully insert the bit
001629
straight until the shoe base is in full contact with the material.
Move the tool slowly with a constant pressure in a clockwise direction to make
the cut.
When cutting straight line, clamp a straight board firmly to the material and use
001630
it as a guide. Move the tool in the direction of the arrow with the shoe base
flush with the side of the guide board.
When the cut is complete, turn the tool off and wait for the bit to stop rotating
and then carefully remove it from the material.