Functional Description - Makita 3706 Instruction Manual

FUNCTIONAL
DESCRIPTION
1. Shoe
2. Thumb screw
OFF
1
1. Switch lever
2. Bump off switch
ASSEMBLY
4
1
6
2
3
7
1. Bit
2. Collet nut
3. Shaft lock
4. Adapter
5. Wrench
6. Loosen
7. Tighten
CAUTION:
• Always be sure that the tool is switched off and unplugged before
adjusting or checking function on the tool.
Adjusting depth of cut
001624
To adjust the shoe, turn the thumb screw to loosen. Slide the shoe to the
1
desired position and tighten the thumb screw securely. Check for the proper
clearance beneath the workpiece before cutting so that the bit will not strike a
hard surface such as the floor, workbench, etc.
2
Switch action
001625
ON CAUTION:
2
• Before plugging in the tool, always check to see that the switch lever
actuates properly and returns to the "OFF'' position.
To start the tool, move the switch lever to the "ON'' position.
To stop the tool, move the switch lever to the "OFF'' position.
This can be done in the forward area of the switch lever or by bumping off the
rear area of the switch lever.
CAUTION:
• Always be sure that the tool is switched off and unplugged before
carrying out any work on the tool.
Installing or removing bit
001626
5
CAUTION:
• Do not tighten the collet nut without inserting a bit, or the collet cone will
break.
• When using the bit with 6.35 mm shank diameter, first remove the
adapter from the collet cone, then install the bit.
To install the bit, insert the bit all the way into the collet cone.
Press the shaft lock to keep the shaft stationary and use the wrench to tighten
the collet nut securely.
To remove the bit, follow the installation procedure in reverse.
5