Makita 6827 Instruction Manual page 7

Adjusting fastening torque
When you wish to drive machine screws,
wood screws, hex bolts etc. with the pre-
determined torque, adjust the fastening
torque as follows.
The fastening torque may be adjusted by
turning the adjusting ring. Before turning
the adjusting ring, turn the locator in the
direction of the arrow as far as it will go
without forcing. The torque is increased by
turning the adjusting ring in the direction of
the arrow and decreased by turning
it
in the
opposite direction. Align the number 1 on
the adjusting ring with the pointer on the
Adjusting
ring
7
7
Locator
2
Pointer
1
gear housing. Drive a trial screw into your material or a piece of duplicate material. If the
fastening torque is not suitable for the screw, continue adjusting until the proper torque is
obtained.
CAUTION:
The adjusting ring should be turned only within the numbered range.
It
should not be
forced beyond this range.
ASSEMBLY
Removing or installing bit
CAUTION:
Always be sure that the tool is switched off and unplugged before removing or installing
the bit.
To remove the bit, first pull the front cap off
and then pull the bit firmly. To install the bit,
insert it into the tool as far as it will go and
then replace the front cap.
7