Makita 6827 Instruction Manual page 6

Hook
The hook is convenient for temporaw hanging the tool. When using the hook, pull it out in
"A" direction and then push it in B direction to secure in place.
When not using the hook, return it back to its initial position
by
following the above proce-
dures in reverse.
Depth adjustment
When you wish to drive self drilling screws,
etc., adjust the depth
as
follows. Turn the
locator to adjust the depth.
Initially, adjust the locator to create a distance of approximately 1 mm
(3/64")
from the tip
of the front cap (which works in conjunction with the locator) to the base
of
the screw
head. One full turn of the locator equals 1
m m
(3/64") change in depth. After adjusting the
locator, turn the adjusting ring so that the 6" mark is aligned with the pointer on the gear
housing. Drive a trial screw into your material or a piece of duplicate material. If the depth
is not suitable for the screw, continue adjusting until the proper depth setting is obtained.
6