Makita CG100D Instruction Manual page 6

WARNING:
A
1. Switch trigger
the trigger-lock button is provided.
by increasing pressure on the switch trigger. Release
the switch trigger to stop.
After use, press in the trigger-lock button from B side.
1.
the lowest speed at 1.
NOTICE:
tool is working.
NOTICE:
of caulking material, it may not be fed at low
NOTICE:
1
B
2
1
CAUTION:
-
1
1. Lamp
seconds after releasing the switch trigger.
NOTICE:
NOTE: Use a dry cloth to wipe the dirt off the lens of
the lamp. Be careful not to scratch the lens of lamp, or
it may lower the illumination.
1. Warning lamp
If the load increases and the tool becomes overloaded,
the tool stops automatically and the warning lamp keeps
on lighting. In this case, release the switch trigger, and
remove the cause of overload, and then restart the tool.
NOTE: When the warning lamp blinks, check the
following points:
6 ENGLISH
1