Installing End Table - Grizzly G1531 Owner's Manual

15. Place one edge of a square against the work
table and the other against the sanding belt
and platen, as shown in Figure 24.
Figure 24. Squaring main work table.
16. Adjust the work table perpendicular to the
sanding platen, tighten the table lock han-
dles, then adjust the pointer to 90˚ (Figure
25).
Figure 25. Pointer set to 90˚.
17. Set the miter body into its pivot hole and
secure into place with the plastic lock knob
" flat washer, as shown in Figure 26.
and /
5
16
The miter body should only be used when
sanding the ends of workpieces at least 8''
long. Do not use it as a back stop.
Figure 26. Miter gauge installed.
-22-

Installing End Table

To install the end table:
1.
DISCONNECT SANDER FROM POWER!
2.
Insert the end table post into the bottom of
the end table so the flat part of the shaft faces
away from the end of the sander, as shown in
Figure 27.
End Table
Post
Thumb
Screws
Figure 27. End table installed.
3. Unscrew the thumb screws, slide the end
table into place, as shown in Figure 27, and
tighten the thumb screws when the table is
at the desired working height. It is not nec-
essary to have the end table mounted at all
times—it can be installed when needed.
NOTICE
Make sure tables do not come in contact
with rotating sanding belt.
Model G1140 G1531 (Mfd. Since 08/14)