Loading Label Rolls - Brady i5100 User Manual

Loading Label Rolls

IMPORTANT! The Brady auto-detect label roll holder is required for Brady Mode printing.
• The holder accepts rolls with a minimum 3" open core.
• The printer will not function properly if the roll is placed directly into the printer without use of the roll holder.
These instructions are for using Brady IP-Enabled supplies that have the RFID tag.
Place Label Roll onto Roll Holder
1. Hold the roll holder with green tab on the right-hand side during loading.
2. Squeeze and hold the green tab on the right margin stop, then slide the margin stop outward and off the holder. Set this aside.
3. With the end of the label media facing you, slide the label roll onto the center core of the holder pushing the roll all the way to the left.
The left margin stop will slide to the left on the holder.
4. Squeeze and hold the green tab on the right margin stop while sliding it back onto the holder and pushing to the left until the margin
stops and the roll auto-centers. Release the green tab.
Insert Roll Holder into Printer
1. Lift the printer cover, lower the front control panel and press the
green release button to raise the print module.
2. Hold the loaded roll holder with green tab on the right-hand side
and face the printer straight-on from the front.
3. Insert the loaded roll holder straight down into the printer making
sure the square tabs on the roll holder drop into the square
grooves in the sides of the printer.
4. Press down carefully on the holder tabs so they are seated firmly
in the grooves. The contacts on the holder must touch the elec-
trical contacts in the grooves of the printer.
18
BradyPrinter i5100