Epson PP-100II Technical Reference Manual page 35

Select [System settings] - [Output device]. Following settings can be made.
Setting Item
Device name
Publish Mode
Mode
Stacker 1,2
Stacker 3
Drive Drive used
Settings
Number of write retries
Printer Show error mark on
Settings discs that experience
errors
You can change the name of PP-100N.
Select the publishing mode from the following three options; "Standard
Mode", "External Output Mode", and "Batch Mode". See the PP-100N
User's Guide for more information on the publishing mode.
When "Standard Mode" is selected:
Select disc type for Stacker 1 that is used for blank discs. Stacker 2 is used
for ejected (published) discs.
When "External Output Mode" is selected:
Select disc type for both Stacker 1 and 2 that are used for blank discs.
When "Batch Mode" is selected:
Select disc type for both Stacker 1 and 2 that are used for blank discs. An
error occurs if the disc type specified for Stacker 1 and 2 is different from
that specified in the JDF file.
When "Standard Mode" is selected:
"Do not use"
When "External Output Mode" is selected:
"Output Stacker" or "Do not use" can be selected:
When "Batch Mode" is selected:
"Output Stacker"
Select the drive to be used for writing data to the blank discs. Select one
from the following three options; "Use Both", "Use Drive 1 Only", and "Use
Drive 2 Only".
Specify the number of retries in the case of writing errors. The number can
be entered in the range of 0 to 9.
Tick the checkbox when you want to print an error mark on published
discs that may have been improperly burnt (an error occurs during
writing). This helps you to separate the failed discs from the normal ones.
Chapter 3 Setting
Explanation
3
35