10. TECHNICAL INFORMATION..................19 FOR PERFECT RESULTS Thank you for choosing this AEG product. We have created it to give you impeccable performance for many years, with innovative technologies that help make life simpler features you might not find on ordinary appliances. Please spend a few minutes reading to get the very best from it.
ENGLISH SAFETY INFORMATION Before the installation and use of the appliance, carefully read the supplied instructions. The manufacturer is not responsible if an incorrect installation and use causes injuries and damages. Always keep the instructions with the appliance for future reference.
Do not use water spray and steam to clean the • appliance. Clean the appliance with a moist soft cloth. Only use • neutral detergents. Do not use abrasive products, abrasive cleaning pads, solvents or metal objects. Do not store explosive substances such as aerosol •...
ENGLISH 2.3 Use • Before maintenance, deactivate the appliance and disconnect the mains WARNING! plug from the mains socket. Risk of injury, burns, electrical • This appliance contains hydrocarbons shock or fire. in the cooling unit. Only a qualified person must do the maintenance and •...
It is possible to change predefined Mode and Temperature colder button sound of buttons by pressing together for some seconds. Change is reversible. Display A) Timer function Set the temperature of the fridge by B) COOLMATIC function pressing the temperature button.
ENGLISH 2. Press the Timer regulator to change The COOLMATIC indicator appears. the Timer set value from 1 to 90 The COOLMATIC mode shuts off minutes. automatically after approximately 6 3. Press OK to confirm. hours. The MinuteMinder indicator is shown. To switch off the function before its The Timer starts to flash (min).
This device activates by itself when needed, for example for a quick temperature recovering after door opening or when the ambient temperature is high. It is possible to switch on the device manually when needed (refer to DynamicAir mode).
ENGLISH 5. HINTS AND TIPS 5.1 Normal operating sounds • do not store warm food or evaporating liquids in the refrigerator The following sounds are normal during • do cover or wrap the food, particularly operation: if it has a strong flavour •...
6. CARE AND CLEANING 6.3 Defrosting of the WARNING! refrigerator Refer to Safety chapters. Frost is automatically eliminated from the 6.1 General warnings evaporator of the refrigerator compartment every time the motor CAUTION! compressor stops, during normal use. Unplug the appliance before...
ENGLISH To get best performance the carbon air Refer to “Installation of the carbon air filter should be changed once every year. filter” for the instructions. New active air filters can be purchased from your local dealer. 7. TROUBLESHOOTING WARNING! Refer to Safety chapters.
Page 12
Problem Possible cause Solution The compressor operates Temperature is set incor- Refer to "Operation" chapter. continually. rectly. Many food products were Wait some hours and then put in at the same time. check the temperature again. The room temperature is Refer to climate class chart on too high.
ENGLISH Problem Possible cause Solution The door is not closed cor- Refer to "Closing the door". rectly. The food products' tem- Let the food products temper- perature is too high. ature decrease to room tem- perature before storage. Many food products are Store less food products at the stored at the same time.
8.3 Electrical Connection Some functional problems might occur for some types of CAUTION! models when operating Any electrical work required to outside of that range. The install this appliance should correct operation can only be be carried out by a qualified...
ENGLISH 4. Check that no cut, or stray strands of 6. Install the spacer. wire is present and the cord clamp 7. Install the door. (E) is secure over the outer sheath. 8. Tighten the upper pin. Make sure the electricity supply 8.5 Ventilation requirements voltage is the same as that indicated on the appliance rating plate.
Page 16
8. Open the door. Put the lower hinge cover in position. 13 mm Ø 2.5 mm 44mm 9. Attach the appliance to the niche with 4 screws. 4. Install the appliance in the niche. 5. Push the appliance in the direction of...
Page 17
ENGLISH ~50 mm ~50 mm 12. Install the vent grille (B). 13. Attach the hinge covers (E) to the hinge. 14. Disconnect the parts (Ha), (Hb), (Hc) 21 mm and (Hd). 16. Push the part (Hc) on the part (Ha). 15.
23. Press the part (Hd) on the part (Hb). 8 mm 20. Remove the small squares and drill holes with ø 2 mm at 8 mm from the Do a final check to make sure that: outer edge of the door.
Frequency The technical information are situated in internal side of the appliance and in the the rating plate, on the external or energy label. 11. ENVIRONMENTAL CONCERNS Recycle the materials with the symbol Put the packaging in applicable containers to recycle it. Help protect the...