NETGEAR WN370 Installation

Installation
Wall Mount Access Point
Model WN370

Package Contents

• Wall Mount Access Point
• Mounting bracket with four mounting screws
• Installation guide

Installation Requirements

The following items are required:
• 6 mm Phillips screwdriver
• T8 screwdriver
• Windows-based computer (Windows 7 or newer operating system)
• Standard EU or US wall outlet junction box with an Ethernet cable routed
through the wall from your LAN to the junction box
• IEEE 802.3af/at–compliant PoE switch or IEEE 802.3af/at–compliant PoE
injector
Network Environment
The WN370 access point can be deployed in a network managed by the following
NETGEAR wireless controller models:
• WC7500
• WC7600v2
• WC7600
• WC9500
If your network includes a DHCP server, option 43 must be enabled pointing
toward the IP address of the wireless controller.
Make sure that you are running the latest firmware version on your device.
To find documentation, firmware, software, or other files, visit
downloadcenter.netgear.com.

Install the Access Point

The access point requires an electrical outlet junction box mounted in a wall.
¾ To install the access point:
1. Remove the faceplate from the outlet junction box.
2. Run the Ethernet cable through the junction box with enough slack to reach
the access point.
3. Run the Ethernet cables through the
mounting bracket.
4. Align the mounting bracket with the holes
on the junction box.
5. Attach the mounting bracket to the
junction box using the included Phillips
head screws.
6. Connect the Ethernet cable providing PoE and network connectivity to the
PoE port on the back of the access point.
7. (Optional) Connect the Ethernet cable providing pass-through support to the
pass-through port on the back of the access point.
8. Mount the access point to the mounting bracket using the included T8
screws.