Honeywell Bendix/King KY 196B Installation Manual page 30

Momentarily pushing the Transfer button returns the radio to Standby Frequency Entry. The
Standby frequency prior to Active Entry mode remains unchanged.
3.1.4 REMOTE FREQUENCY TRANSFER
The Remote Frequency Transfer button operates identically to the front panel Transfer button with
the exception that holding the Remote Transfer button for two seconds does not place the radio in
the Active Entry mode.
3.1.5 REMOTE CHANNEL INCREMENT
Pressing the Remote Channel button will cause the system to enter the Channel mode of operation
and will increment the channel from the previous channel number used.
3.1.6 DIM SELECT
DIM SELECT LINE STATUS
KY 196B (Pin A)
+28VDC
OPEN
GND
3.1.7 DISPLAY ADJUST MODE
Press and hold the Channel button, when the unit enters program mode, press and hold the transfer
button for more than 2 seconds so that DA 1 replaces the frequency in the USE window. The unit
is now in display adjust mode, refer to the table below for a description of the 3 DA modes and
ranges of operation. The increment and decrement knobs are used to set the proper value in the
STANDBY window. Momentarily pressing the CHAN button increments the unit thru the 3 display
adjust modes (DA 1 Thru DA 3). Press the transfer button to exit display adjust mode.
MODE RANGE
DA 1 1 to 8
DA 2 0 to 64
DA 3 0 to 255
10570I01.ZIPCDL
Rev 1 January/2000
BENDIX/KING
KY 196B
VHF COMMUNICATIONS TRANSCEIVER
DISPLAY STATUS
MAX BRIGHT
FOLLOW PHOTOCELL
DIMMER BUS
DESCRIPTION
Display brightness (1=fast, 8=slow)
Response to dimmer photocell (0=dim, 64=bright)
Display age compensation for brightness (0=dim, 255=bright)
Page 3-3