Hand Crimper; Crimp Jaws - Honeywell Bendix/King KY 196B Installation Manual

2.3.6 MOLEX TERMINAL INSTRUCTIONS
The Molex hand crimpers are available under P/N 071--06041--0000, or from Molex under P/N
6115.
Holding the hand crimpers as shown, release the crimper's ratchet pawl and open by squeezing
tightly on the handles, and then releasing pressure.
Close crimpers until ratchet begins to engage. Then insert the terminal into the jaws from the back
side. (See Figure 2- -3
jaw A and then complete it in jaw B. The terminal is in the correct position when the insulation tabs
are flush with the outside face of the crimp jaws.
JAW TERMINAL
A 030-01107-0030
B 030-01107-0030
10570I01.ZIPCDL
Rev 1 January/2000
BENDIX/KING
KY 196B
VHF COMMUNICATIONS TRANSCEIVER
FIGURE 2- -2 HAND CRIMPER
and 2- -4) For 24 to 30 AWG wire, it will be necessary to start the crimp in
WIRE SIZE
18 TO 24 AWG
24 TO 30AWG
FIGURE 2- -3 CRIMP JAWS
INSULATION RANGE
.110 TO .055
.055 TO .030
Page 2-5