In-Line Transmitter; Service And Repair - RIDGID 120V Operator's Manual

Black and White Monitor
Activating the

In-Line Transmitter

Figure 12 – Dimmer/Transmitter Knob in Transmitter
Position
1. Locate the Dimmer/Transmitter Knob.
2. For normal camera operation, the Dimmer/Trans-
mitter Knob should be in the dimmer control area
(yellow band). This area adjusts the camera's LED
lighting. See Figure 12.
3. When you are ready to do a locate, rotate the dim-
mer/transmitter knob counter-clockwise until it snaps
into the transmitter position (red dot). See Figure
12. The Transmitter is now activated. You will notice
lines of interference on the monitor and the LEDs on
the power supply will flash with a steady pattern
when the transmitter is activated.
4. When you are finished with the locate, turn the
Dimmer/Transmitter Knob clockwise to the dimmer
control area to resume normal camera operation.
10
+ VCR, Color Monitor + VCR
Dimmer/Transmitter
Knob
Ridge Tool Company

Service and Repair

WARNING
Tool should be taken to a RIDGID Independent Author-
ized Service Center or returned to the factory. All repairs
made by Ridge service facilities are warranted against de-
fects in material and workmanship.
If you have any questions regarding the service or repair
of this machine, call or write to:
Ridge Tool Company
Technical Service Department
400 Clark Street
Elyria, Ohio 44035-6001
Tel: (800) 519-3456
E-mail: TechServices@ridgid.com
For name and address of your nearest Independent
Authorized Service Center, contact the Ridge Tool Com-
pany at (800) 519-3456 or http://www.ridgid.com or
www.seesnake.com