Removing And Replacing The Motor Vibrator Assembly - Motorola V235 Service Manual

Disassembly

Removing and Replacing the Motor Vibrator Assembly

G
G
40
1. Remove the battery cover, battery, SIM, antenna, rear housing, and
transceiver board assembly, flip assembly cover, and CLI lens cover as
described in the procedures.
The flexible printed cable (FPC) (flex) is easily damaged. Exercise extreme care when
handling.
2. Use the disassembly tool to carefully lift the motor/vibrator assembly and flex
from the flip assembly (see Figure 22). .
Figure 22. Motor/Vibrator Assembly Removal
The flexible printed cable (FPC) (flex) is easily damaged. Exercise extreme care when
handling.
3. Slide the flex connector through the opening in the flip hinge.
4. To replace, thread the flex connector through the slot in the flip hinge.
5. Remove the adhesive backing from the motor/vibrator and flex.
6. Align the motor/vibrator to its location in the flip assembly.
7. Gently but firmly press the motor/vibrator and flex into it's pocket until
properly seated in the flip assembly.
8. Replace the camera assembly, display assembly, flip assembly cover, flip
assembly, transceiver board, rear housing, antenna, SIM, battery, and battery
cover as described in the procedures.
Motor/Vibrator/Flex
April 03, 2006
V235 GSM
6809495A43-C