Using The Cli For Configuration - Cisco ASA 5505 Getting Started Manual

Using the CLI for Configuration

Using the CLI for Configuration
ASA 5505 Getting Started Guide
5-2
Allocated switch ports Ethernet 0/1 through Ethernet 0/7
–
Security level of 100
–
Allocated switch ports Ethernet 0/1 through 0/7
–
IP address of 192.168.1.1 255.255.255.0
–
VLAN2 has the following properties:
•
Named "outside"
–
Allocated switch port Ethernet 0/0
–
Security level of 0
–
Configured to obtain its IP address using DHCP
–
Inside interface to connect to the device and use ASDM to complete your
•
configuration.
By default, the adaptive security appliance Inside interface is configured with a
default DHCP address pool. This configuration enables a client on the inside network
to obtain a DHCP address from the adaptive security appliance to connect to the
appliance. Administrators can then configure and manage the adaptive security
appliance using ASDM.
In addition to the ASDM web configuration tool, you can configure the adaptive
security appliance by using the command-line interface.
You can get step-by-step examples of how to configure basic remote access and
LAN-to-LAN connections in the CLI itself by using the vpnsetup
ipsec-remote-access steps and vpnsetup site-to-site steps commands. For more
information about these commands, see the Cisco Security Appliance Command
Reference.
For step-by-step configuration procedures for all functional areas of the adaptive
security appliance, see the Cisco Security Appliance Command Line
Configuration Guide.
Chapter 5 Configuring the Adaptive Security Appliance
78-18003-02