Makita HR166D Instruction Manual
Hide thumbs
Also See for HR166D:
- Instruction manual (72 pages) ,
- Instruction manual (69 pages) ,
- Instruction manual (16 pages)
Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for Makita HR166D
Summary of Contents for Makita HR166D
- Page 1 INSTRUCTION MANUAL Cordless Rotary Hammer HR166D Read before use.
-
Page 2: Specifications
SPECIFICATIONS Model: HR166D Drilling capacities Concrete 16 mm Steel 10 mm Wood 13 mm No load speed 0 - 680 min Blows per minute 0 - 4,800 min Overall length 250 mm Rated voltage D.C. 10.8 V - 12 V max... - Page 3 Personal Safety Use the power tool, accessories and tool bits etc. in accordance with these instructions, tak- Stay alert, watch what you are doing and use ing into account the working conditions and common sense when operating a power tool. the work to be performed.
- Page 4 WARNING: DO NOT let comfort or familiarity with product (gained from repeated use) replace also void the Makita warranty for the Makita tool and strict adherence to safety rules for the subject charger. product. MISUSE or failure to follow the safety...
-
Page 5: Functional Description
Indicating the remaining battery FUNCTIONAL capacity DESCRIPTION Only for battery cartridges with the indicator CAUTION: Always be sure that the tool is switched off and the battery cartridge is removed before adjusting or checking function on the tool. Installing or removing battery cartridge CAUTION: Always switch off the tool before... - Page 6 Overdischarge protection Reversing switch action When the battery capacity is not enough, the tool stops automatically. If you turn the tool on, the motor runs again but stops soon. In this case, remove the battery from the tool and charge the battery. Switch action WARNING: Before installing the battery car-...
- Page 7 1. Side grip Grease Rotation only For drilling in wood, metal or plastic materials, rotate Coat the shank end of the drill bit beforehand with a the action mode changing knob to the small amount of grease (about 0.5 - 1 g). twist drill bit or wood drill bit.
-
Page 8: Depth Gauge
1. Drill bit 2. Chuck cover 1. Dust cup Depth gauge Dust cup set (optional accessory) NOTICE: Do not use the dust cup set when drill- uniform depth. Loosen the side grip and insert the depth ing in metal or similar. It may damage the dust cup set due to the heat produced by small metal dust or gauge to the desired depth and tighten the side grip similar. - Page 9 1. Dust cap secure it. way and pull the drill bit out. 1. Side grip Install the dust cup set so that the claws of the dust cup 1. Bit 2. Chuck cover and pull it out. 1. Dust cup 1.
-
Page 10: Operation
Do not apply more pressure when the hole becomes clogged with chips or particles. Instead, run the tool at an idle, then remove the drill bit partially from the hole. By repeating this several times, the hole will be cleaned out and normal drilling may be resumed. -
Page 11: Maintenance
OPTIONAL ACCESSORIES CAUTION: These accessories or attachments are recommended for use with your Makita tool accessories or attachments might present a risk of for its stated purpose. If you need any assistance for more details regard- ing these accessories, ask your local Makita Service Center. - Page 12 M a k i t a C o r p o r a t i o n 3-11-8, Sumiyoshi-cho, Anjo, Aichi 446-8502 Japan 20170124 www.makita.com...