Service
Manual
Before any intervention it is essential to cut off all supply of the machine
Repair
Replacement of the V1 jack:
Remove / Assembly:
1. Remove the rear housing of the machine.
2. Remove the compressed air supply of the faulty jack.
3. Remove the rod linkage of the jack.
4. Remove the jack and replace it by a new one.
5. Put the new jack on the rod linkage.
6. Connect the compressed air supply on the new jack.
7. Put back the rear housing.
Replacement of the V2 and V3 jacks:
Remove / Assembly:
1. Remove the rear housing of the machine.
2. Remove the compressed air supply of the faulty jack.
3. Remove the knife of the jack.
4. Remove the jack of the support connection angle and replace it by a new one.
5. Put the new jack on the knife.
6. Connect the compressed air supply on the new jack.
7. Put back the rear housing.
04102011/GB
06.2009
Cross folding
(electricity, steam, water, gas, compressed air...).
33
9