SET1000000
10 Installing I/O Unit B (IOUB)
36
- This chapter describes the procedure for installing I/O Unit B.
- In this chapter, IOUB represents I/O Unit B.
- In this chapter, IOU#0 and IOU#1 represents IOUB installation location.
SET1001000
10.1 Conditions for installing components
- When installing IOUB at IOU#0 location, installing SB at installation of SB#0 and SB#1 is necessary
for using all PCI slots of IOUB. (See "Table 10.1".)
- When installing IOUB at IOU#1 location, installing SB at installation of SB#2 and SB#3 is necessary
for using all PCI slots of IOUB. (See "Table 10.1".)
System board installation location
SB#0
SB#1
SB#2
SB#3
SET1001010
10.1.1 Firmware version
- No conditions.
SET1001020
10.1.2 Maximum installation amount
- 2 units.
SET1001030
10.1.3 Conditions concerning combined use of IOUB
- No conditions.
SET1001040
10.1.4 Base Unit state
- AC power to the Base Unit is off.
Table 10.1 Connection from SB to each IOUB
IOUB installation location
IOU#0
Slot#0,#1,#2,#3
Slot#4,#5,#6,#7
-
-
66
IOU#1
-
-
Slot#0,#1,#2,#3
Slot#4,#5,#6,#7