Installing Sfps; Removing Sfp Modules - Cisco 1100 Series Installing And Upgrading

Integrated services router

Hide thumbs Also See for 1100 Series:

Table of Contents

Installing and Upgrading Internal Modules and FRUs

Installing SFPs

Follow these steps to remove an SFP from the router:

Step 1

Read the Safety Warnings section and disconnect the power supply before you perform any module replacement.

Step 2

Disconnect all cables from the SFP.

Invisible laser radiation may be emitted from disconnected fibers or connectors. Do not stare into beams or

Warning

view directly with optical instruments. Statement 1051

The latching mechanism used on many SFPs locks the SFP into place when cables are connected. Do not

Caution

pull on the cabling in an attempt to remove the SFP.

Step 3

Disconnect the SFP latch.

SFP modules use various latch designs to secure the module in the SFP port. Latch designs are not linked to

Note

SFP model or technology type. For information on the SFP technology type and model, see the label on the side

of the SFP.

Use a pen, screwdriver, or other small straight tool to gently release a bale-clasp handle if you cannot reach it

Tip

with your fingers.

Step 4

Grasp the SFP on both sides and remove it from the router.

Hardware Installation Guide for the Cisco 1100 Series Integrated Services Router

Installing and Removing SFP Modules

Table of Contents