Installation; Parts Description - Makita AT638A Instruction Manual And Users Manual

17. Never attempt to drive fasteners from both the
inside and outside at the same time. Fasteners
danger.
Service
1. Perform cleaning and maintenance right after
tion. Lubricate moving parts to prevent rusting and
from the parts.
2. Ask Makita authorized service center for peri-
odical inspection of the tool.
3. To maintain product SAFETY and RELIABILITY,
maintenance and repairs should be performed
by Makita Authorized Service Centers, always
using Makita replacement parts.
SAVE THESE INSTRUCTIONS.
WARNING:
DO NOT let comfort or familiarity
with product (gained from repeated use) replace
strict adherence to safety rules for the subject
product. MISUSE or failure to follow the safety
rules stated in this instruction manual may cause
serious personal injury.

PARTS DESCRIPTION

2
1. 2. Nose adapter (contact element)
3. Hook 4.
Keep the tool in tip-top condi-
3
1

INSTALLATION

Selecting compressor
60
50
40
2
30
20
10
1.
MPa (6.6 bar) 5. 0.49 MPa (4.9 bar)
Select a compressor that has ample pressure and air
ble pressure and compressor air output.
approximately 60 times per minute at a compression
Pressure regulators must be used to limit air pressure to
the rated pressure of the tool where air supply pressure
exceeds the tool's rated pressure. Failure to do so may
vicinity.
Selecting air hose
CAUTION:
or a long or smaller diameter air hose in relation
4
to the stapling frequency may cause a decrease in
the driving capability of the tool.
4 ENGLISH
10 20 30 40
1
2. Compressor air
3. 0.83 MPa (8.3 bar) 4. 0.66
Low air output of the compressor,
3
4
5
50 60
-