Procedure 4-1: Configuring A Network To Network Vpn Tunnel - NETGEAR FVM318 Reference Manual

Reference Manual for the Model FVM318 Cable/DSL ProSafe Wireless VPN Security Firewall

Procedure 4-1: Configuring a Network to Network VPN Tunnel

Follow this procedure to configure a VPN tunnel between two LANs via a FVS318 at each end.
A
Figure 4-2: LAN to LAN VPN access through an
Set up the two LANs to have different IP address ranges.
1.
The procedures below refer to the
Configuration Worksheet" on page
To configure your actual network, print and fill out the blank
Tunnel Configuration Worksheet" on page 4-26
the procedures below.
Log in to the first FVS318 firewall (A) at its default LAN address of http://192.168.0.1
a.
with its default User Name of
whatever User Name, Password you have set up.
4-4
"Sample Network to Network IKE VPN Tunnel
4-3.
for your network configuration. Then follow
admin and default Password of
Figure 4-3: Log in
B
FVS318 FVS318
to an
"Network to Network IKE VPN
password , or using
Virtual Private Networking