Quick Start; Mouunting And Installation - GE ICRXIDIXNE19LCTA Quick Start Manual

5
Quickstart
Note: For specifications, mounting and installation requirements and procedures, and operating information, refer to
GFK-2898, PACSystems 19" RXi Display User Manual.
Note: For user manuals, product updates, and other information, go to the Support website,
http://www.ge-ip.com/support
Upon receiving the RXi Display, carefully inspect all shipping containers for damage. If any part of the system is damaged, notify
the carrier immediately. The damaged shipping container should be saved as evidence for inspection by the carrier.
As the consignee, it is your responsibility to register a claim with the carrier for damage incurred during shipment. However, we
will fully cooperate with you should action be necessary.
After unpacking the RXi Display, record all serial numbers. Serial numbers are required if you need to contact Customer Care
during the warranty period. All shipping containers and packing material should be saved should it be necessary to transport or
ship any part of the system.
Note: For phone numbers and email addresses, refer to the section
Verify that all components of the system have been received and they agree with your order. If not, contact Customer Care. For
technical help, contact Technical Support.
Before attempting to power up the RXi Display for the first time, inspect the unit for loose or damaged components. If damage is
observed (such as bent component leads or loose components), contact GE Intelligent Platforms. Depending on the severity of
the damage, it may be necessary to return the product to the factory for repair.
Note: Do not apply power to the unit if it has visible damage. Applying power to a unit with damaged components may
cause additional damage.

Mouunting and Installation

The RXi display is mounted directly onto a panel or enclosure. Adhere to the following guidelines for mounting and installation:
•
The RXi Display should be mounted on a flat surface in a UL/NEMA Type 1 enclosure.
•
The RXi Display must be mounted with its cooling fins vertical to ensure adequate air flow. Mounting orientation is
permitted only with connectors oriented down.
• The panel should be capable of supporting the weight of the RXi Display without distortion to the panel.
• Adequate air flow around the exterior of the unit is essential to maintain safe interior temperature of the unit. Inlets and
outlets must not be obstructed.
• You may need to allow more space for installation of cables and connectors than what is required for heat dissipation. To
avoid impacting mechanical reliability and signal quality, cable installation must comply with the minimum bend radius
specified by the cable manufacturer.
and refer to Operator Interfaces and PC Solutions.
PACSystems RXi 19" Display QSG
Contact Information.
GFK-2899B