Functional Description - Makita M4000 Instruction Manual

a tripping current of not more than 30 mA;
Operation
9. Always direct the cable to the rear away from the
appliance.
10. If a cord becomes damaged during use,
disconnect the supply cord from the mains
immediately. DO NOT TOUCH THE CORD
BEFORE DISCONNECTING THE SUPPLY.
11. Do not carry the appliance by the cable.
12. Disconnect the appliance from the mains supply.
−
whenever you leave the machine;
−
before clearing a blockage;
−
before checking, cleaning or working on the
appliance;
−
if the appliance starts to vibrate abnormally.
13. Operate the appliance only in daylight or in good
artificial light.
14. Do not overreach and keep your balance at all times.
15. Always be sure of your footing on slopes.
16. Walk, never run.
17. Keep all cooling air inlets clear of debris.
18. Never blow debris in the direction of bystanders.
19. Never block suction inlet and/or blower outlet.
−
Do not block suction inlet or blower outlet
to clean up in dusty areas.
−
Do not use the blower with a tapered
nozzle smaller than the original one, such
as a new nozzle obtained by attaching an
extra diameter-reduced hose or smaller
hose to the nozzle top end.
−
Do not Use the blower to inflate balls,
rubber boat or the similar.
Increased motor revolution may cause dangerous
fan breakage and result in serious personal injury.
Heated motor and control circuit may cause a fire.
20. It is recommended to use the long nozzle so
the air stream can work close to the ground.
Maintenance and storage
21. Keep all nuts, bolts and screws tight to be sure
the appliance is in safe working condition.
22. Check the debris collector frequently for wear or
deterioration.
23. Replace worn or damaged parts.
24. Use only genuine replacement parts and accessories.
25. Store the appliance only in a dry place.
SAVE THESE INSTRUCTIONS.
WARNING:
DO NOT let comfort or familiarity with product (gained
from repeated use) replace strict adherence to safety
rules for the subject product. MISUSE or failure to
follow the safety rules stated in this instruction manual
may cause serious personal injury.

FUNCTIONAL DESCRIPTION

CAUTION:
Always be sure that the tool is switched off and
•
unplugged before adjusting or checking function
on the tool.
Switch action
CAUTION:
Before plugging in the tool, always check to see
•
that the switch trigger actuates properly and
returns to the "OFF" position when released.
1
013219
To start the tool, simply pull the switch trigger. Release
the switch trigger to stop.
For continuous operation, pull the switch trigger and
then push in the lock button, and then release the
switch trigger.
To stop the tool from the locked position, pull the switch
trigger fully, then release it.
Air volume adjusting dial
B
A
013220
Air speed and volume can be adjusted without positive
stops by turning the air volume adjusting dial.
To obtain high speed and increase volume, turn the air
volume adjusting dial to the A direction shown in the
figure (for the bigger number). Turn the air volume
adjusting dial to the B direction (for the smaller number)
to obtain low speed and to decrease the air volume.
3
1. Switch trigger
2
2. Lock button
1. Air volume
adjusting dial
1